Acrobat X Files

Home > Automotive > Toyota

SPARCO HARNESS BAR 19931998 TOYOTA SUPRA PART # 30014

Sort Desciption:

belt bolt cover and remove the upper bolt as shown here. Disassemble the factory hardware. SPARCO HARNESS BAR. 19931998 TOYOTA SUPRA. PART # 30014 ...

Content Inside:

SPARCO HARNESS BAR 19931998 TOYOTA SUPRA PART # 30014Page 1DISCLAIMERMotorsports are dangerous. No warranty or representation is made as to products ability to protect the user from any injury or death;the user assumes that risk. Sparco Motor Sports products are legal in all 50 states for use on racing vehicles which may never be used on a highway. Not applicable or intended for street or highway use. INSTALLATION1. Assemble the harness support rods as shown below using the provided heim joints and nuts. Leave at least of threadshowing on each heim joint to allow for adjustment during installation. Do not fully tighten the nuts at this time. NOTE: The end of the support rod with the line around it is reverse thread. There are 2 reverse thread heim joints and nuts aswell. 2. On both sides of the vehicles interior unsnap the plastic upper seat belt bolt cover and remove the upper bolt as shown here. Disassemble the factory hardware. SPARCO HARNESS BAR 19931998 TOYOTA SUPRA PART # 30014Page 23. Using the factory hardware as shown here install the harness bar into the vehicle. Do not fully tighten at this time.4. Remove the factory seat bolt cover and remove the bolt. Remove the lower belt mountbolt. 5. Connect the lower support rod bracket to the factory belt mounting location using the hardware shown here. Preinstall the bolt for the support rod before installing bracket into vehicle (see next page).Page 36. This is how the bracket should look once installed inthe vehicle.7. Connect the support rods to the lower bracket and harness bar with the supplied bolts nuts and washers. 8. Check for proper installation and adjust as necessary. Tighten all bolts and nuts. The finished installation should look likethis:

Source: www.sparcousa.com

 

Related Files

INSURANCE INSTITUTE FOR HIGHWAY SAFETY

Filed under: Automotive and Toyota
Toyota Supra and two Volvo models the 850 and 960. In contrast dozens. of vehicles have head restraints that are neither high enough nor close ...

Toyota Supra MKII Installation Manual Firmware Version 3.0

Filed under: Automotive and Toyota
Toyota Supra MKII Installation Manual Firmware Version 3.0. Warnings:. Before proceeding you are obligated to read and agree to the terms and conditions ...

SuperFlex Toyota Supra MA61 SA61 MA70 & MA71

Filed under: Automotive and Toyota
TOYOTA. SUPRA MA70 MA71 3/1986 12/1992. SPF1443K. Front Lower Arm Inner Bush with Bonded Steel Thrust Washers &. Zinc Plated Steel Tubes Kit of 4 1 only ...

SPARCO HARNESS BAR 19931998 TOYOTA SUPRA PART # 30014

Filed under: Automotive and Toyota
belt bolt cover and remove the upper bolt as shown here. Disassemble the factory hardware. SPARCO HARNESS BAR. 19931998 TOYOTA SUPRA. PART # 30014 ...

TOYOTA SUPRA JGTC

Filed under: Automotive and Toyota
TOYOTA SUPRA JGTC. Hornby Hobbies Ltd Westwood Margate. Kent CT9 4JX England United Kingdom. Printed in England. Service Sheet No.392 ...